Gary Surrency provided part of the answer.
He suggested that I reset the bias adjustment and re-calibrate the SWR
bridge. After doing this, I'm no longer getting hum on 80m, and on
160m, the hum is reduced.
So, if any of you do the KPA100 upgrade, be sure to re-do these
calibrations.
On Aug 16, 2004, at 1:19 AM, Ron D'Eau Claire wrote:
Your idea of hum coming from higher current sounds plausible here,
Bill.
You didn't say what your K2/100 is actually drawing but, yes, mine
draw more
current on 160 and 80 than on most other bands.
I plugged in a dummy load and here's what mine requires at 100 watts
on each
band:
160m = 17.5 amps
80m = 17 amps
40m = 14 amps
30m = 15 amps
20m = 14.5 amps
17m = 17 amps
15m = 17.5 amps
10m = 15 amps
That's total current reported by my Astron power supply.
Ron AC7AC
-----Original Message-----
During a recent contest, I received a report of poor signal quality on
my CW signal on 80m.
I've run some tests and find that on 80m and 160m, there's a distinct
hum on the signal when running over about 80 watts. I've also noticed
that the current used seems to jump in discrete steps as I increase the
power level. It could be that this hum is present on the power supply
at higher current levels. On 160m, the rig pegs the scale on my power
supply ammeter when running full power.
Do the current requirements of the KPA100 increase on these bands? And
what would cause the discrete steps in current consumption at the
higher power levels? We're talking a jump in current about every 10
watts or so.
Prior to the contest, I performed the KPA100 modifications for high SWR
operation and installed the new firmware. I've noticed that the heat
sink is running noticeably hotter than before. This while transmitting
into a 50 ohm dummy load.
Any suggestions would be appreciated. The rig appears to operate just
fine, I'm just a little concerned about the signal quality and the
extra heat.
Bill Coleman, AA4LR, PP-ASEL Mail: [EMAIL PROTECTED]
Quote: "Not within a thousand years will man ever fly!"
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
Bill Coleman, AA4LR, PP-ASEL Mail: [EMAIL PROTECTED]
Quote: "Not within a thousand years will man ever fly!"
-- Wilbur Wright, 1901
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com