Thanks guys. She is working now, just dont have squat for drive on SSB. When I "tune" she looks good but the MD2 will barely get a couple watts.
Keep tweaking :) Rich ----- Original Message ----- From: "W9DHI" <[EMAIL PROTECTED]> To: "'Rich McCabe'" <[EMAIL PROTECTED]> Sent: Wednesday, August 25, 2004 6:33 PM Subject: RE: [Elecraft] Re: Archives and 160 no TX > You always have to run Cal on 40 meters......that's an errata in the 160 > manual. > > > Gregg R. Lengling, W9DHI, Retired > Administrator http://www.milwaukeehdtv.org > K2/100 S#3075 KX1 S# 57 > Member: ARRL, RSGB, RCA, WERA and ORC > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Rich McCabe > Sent: Wednesday, August 25, 2004 5:40 PM > To: Elecraft Reflector > Subject: [Elecraft] Re: Archives and 160 no TX > > Well found the archives so nevermind on that. I was being sleepy last not > and forgot to do the CAL PLL. But now when I try it at 1800.10 I get an Info > 232 error. > > Any ideas? > > > ----- Original Message ----- > From: "Rich McCabe" <[EMAIL PROTECTED]> > To: "Elecraft Reflector" <elecraft@mailman.qth.net> > Sent: Wednesday, August 25, 2004 5:24 PM > Subject: Archives and 160 no TX > > > > Didn't there used to be archives of this mail list somewhere that someone > > indexed? > > > > I just installed my 160 board and have no TX. I was getting sleepy when I > > finished it so might have been "dumb" :) > > > > I seemed to remember something from the last K2 I built but cant remember. > > Can someone direct me to where that is located if its still around? > > > > Thanks, > > > > Rich > > > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
