Check the CAL TPA temperature setting in your MENU, Stephen. It's been a while and I've forgotten the exact cause, but a number of ops discovered that the temperature setting was suddenly way off, causing the fan to run constantly. Somehow the initial setting got over-written.
Ron AC7AC -----Original Message----- After a month of so of minimal use my elecrafter k2 .. with the 100 pa has started to act oddly when powered on The transceiver goes immediately to a mode with the pa fan on and says it is over hot ... if I tune then the fan powers down and the transceiver behaves itself. I suspect this might be a software issue with the detection of temp by the pa thermistor .. has anyone else had similar experience and can anyone suggest a fix? Thanks Stephen zl1any _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com