On my first K2 I soldered in a 10 turn 1k pot so did not go as high as 1200.
Have not tried it on the second K2, but will probably give it a try this
weekend.
Funny you would mention the KAT100. Built one last night and building
another this weekend. The CAL went OK on this one.
For those interested in the AT, it is a blast to build and looks/works
awesome. Took about 6 1/2 hours including making cables. Piece of cake :)
Rich
----- Original Message -----
From: "Michael Harris" <[EMAIL PROTECTED]>
To: "Rich McCabe" <[EMAIL PROTECTED]>
Cc: "Elecraft Reflector" <elecraft@mailman.qth.net>
Sent: Wednesday, September 22, 2004 4:10 PM
Subject: Re: [Elecraft] K2/100 power-out change
Rich,
Further to my earlier posting. The resistor to change is R98 on the RF
board. I have changed mine from 270 ohms to 1200 ohms and that completely
removed the power hunting.
Without doing this it is almost impossible to properly set up the KAT100
if you build one.
Regards,
Mike VP8NO
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
