I observed that sometime, 1 out of 100, when I turn Z1 to change or
tune frequency, it goes up only 0.01 or down 0.01 too and stuck at this
frequency. But if I only tork a little, little bit the Z1 encoder,
everything return to normal every time.
What is it wrong with the Z1 encoder, bad or defective ??? Everything
is well soldered, nothing touch nothing, no cold soldered..... and
everything is working flawlessly.
===============================================
Jean-François Ménard / VA2VYZ / FN45aj
[EMAIL PROTECTED]
Elecraft K2 #4130
Site Internet: http://homepage.mac.com/jfmenard
===============================================
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
