I'm not sure I understand the K2's "SSB C r" firmware command or if I am using it properly.
Am I correct in stating that it's main purpose is to use a different compression (usually 1-1 ) than that which is set by SSB C ? I use my K2 to run PSK 31 (mostly on 20 meters) and would like to avoid having to turn off the compression, so this setting would make sense. I have, of course, set RTTY to "On" I have set Fl1 through FL4 to the same bandwidths for both modes but it seems as though I am getting a lot more PSK31 signals on my screen when I use the "U" mode than I do using the "r" mode. (On 20 mtrs I am using CW reverse with the "r" mode - I think that is right.) This is not a big deal as I can continue using the "U" mode and manually change the compression setting, but I thought I should understand what the "r" setting is all about. Thanks Tom WB2QDG K2 1103 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com