Dwight,
I've been through similar problems a couple of times. The first place to
start is find the 'Cheap and Dirty Signal Tracing' document on the Elecraft
Web Site at
http://www.elecraft.com/TechNotes/SigTr/K1%20Cheap%20'n%20Dirty%20Signal%20Tracing.pdf.
If that does not point to the problem I have found some bad solder joints in
the premix filter.
Another thing to do is spin the filter caps about 20 times each. Then start
checking the relays in the premix filter when set to 15 meters and the
crystal if you have a general coverage receiver available. I'm assuming you
are like me without a lot of test equipment?
Good Luck.
Rick
WA3TUU
From: "Dwight" <[EMAIL PROTECTED]>
Reply-To: Dwight <[EMAIL PROTECTED]>
To: "elecraft" <elecraft@mailman.qth.net>
Subject: [Elecraft] K1 / KFL1-4 / Question
Date: Sun, 21 Nov 2004 20:04:06 -0500
Group,
Did the normal search of the archives and elecraft website, without luck.
Biulding a KFL1-4 and got to the Receiver Alignment section. My problem is
with the 15 meter section. Can not hear a signal what so ever. The 40, 30
and 20 meters I can hear signals.
Can anyone point me in the right direction? I seem to be missing it this
weekend.
Dwight N4GSD
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
