Hello K2 Reflectees (??) When building up a new K2; would it eliminate some redundent motions while working in a particular area of construction. to install a particular option? If so, is there a flow chart available?
Carry on Bill_Harris > I'm not sure that's right. Every time I've seen much attenuation, I've not > been on the right freq. If you look at the height of the peak in > Spectrogram, it doesn't drop much as you cycle through the widths. A > primative zero-beat was to go to 100Hz bw, and peak the volume. > > Or, a filter center not near the input pitch will attenuate (by design) > greatly. > > Dan / WG4S / K2 #2456 > > <snip> > W3FPR - Don Wilhelm > ... allow better rejection than a narrower filiter and avoid the attenuation > that occurs with very narrow filters. > </snip> > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com