My new MD2 microphone should arrive tomorrow, and I am trying to decide what to do about the resistor between pin 6 and pin 1. I have a hand microphone with a Heil HC-4 and a N0MF pre-amp in it that I want to continue to use. It has a 1k resistor between pin 1 and pin 6 in per the instructions for the pre-amp.
It seams I have three options. 1. Remove the 1k resistor from the hand microphone, and install the 5.6k resistor in the K2. Will this provide enough current to run the pre-amp in the hand microphone? 2. Add the 5.6k resistor to the K2 and leave the resistor in the hand microphone. Will the hand microphone then draw too much current? 3. Put the 5.6k resistor in the MD2. I know this will work, but requires fitting the resistor into the connector. What is the best option? Jeff Burns AD9T _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
