Ken,
Either C2 or C2A is to be installed on page 38 of the manual (at least that
is the page in Rev F). The board location is below L1 and just above RP2. -
If you installed C2, then C2A will be left over.
On your 30 meter problem - you can try listening for the 18.1 MHz oscillator
on another receiver. Do recheck all the soldering on your 4 band board to
be certain everything is well soldered and that there are no unsoldered
connections. Try re-aligning on 30 meters - you should find a good peak.
For the transmit frequency problem, recheck the Transmit Offset Adjustment,
and then re-do the operating frequency calibration.
73,
Don W3FPR
----- Original Message -----
Hi, with my K1-4; serial #1951 I have the following symptoms/problems. I
sure will appreciate any help given.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
