Vic, thanks for the reply. Just rechecked it and that's not the cause. It was in TP1, per the instructions.
----- Original Message ----- From: "Vic Rosenthal" <[EMAIL PROTECTED]> To: "Mike" <[EMAIL PROTECTED]> Cc: "Elecraft" <elecraft@mailman.qth.net> Sent: Sunday, January 02, 2005 1:41 PM Subject: Re: [Elecraft] Trouble with Alignment and Test, Part II - - - MORE INFO > Mike wrote: > > > Info 232. The troubleshooting section says that the message "...is most > > likely to be displayed if you use CAL PLL without first selecing 40 meters." > > I am, of course, selecting 40 meters. So it looks like it is not recognizing > > the fact that 40 meters is selected. > > Another common cause of this is not having the probe in the correct test point. > > -- > 73, > Vic, K2VCO > Fresno CA > http://www.qsl.net/k2vco > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
