Hi,

I am just at the first alignment and test stage of my K2. Everything checked out just fine except the step where I am to adjust R1 on the control board for 3.80 v on pin 5 of U2. The highest I can get the voltage to go is 3.38v. Is this something to worry about? If so, any clues?

Thanks
Neal - k3nc

_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply via email to