On Tue, Jan 04, 2005 at 07:55:46PM -0600, Lars Edwards wrote: > Hoping I can get some advice from some other owners on this > > I've run into an INFO232 message when trying to run the CAL PLL for the 160 > meter module. > > The manual for the 160 module gives advice on INFO 231 and 235 but not on > INFO 232 > > Up to this point all checks appeared to be ok. > > I do have a note in my owners manual to the effect that if INFO 232 shows up > during CAL PLL make sure that the counter is on TP1 (it is) and that 40M is > selected. > > The 160 meter manual says to set @ 1800.1 kHz and run the CAL PLL.
That was the correct procedure at the time the K160RX came out. The errata sheet says that with K2 firmware 2.00 and later, CAL PLL should only be run on 40 meters. 73, Bob N7XY _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com