That will work OK with the K2/100 keyout line. We're already back emf
protected.
73, Eric
James Brown wrote:
Eric:
My SB-220 uses +123VDC through a 5Kohm relay coil keyed to ground. There
is no diode protection from back-emf across the relay coil, but there is
a .02mfd cap on the low side of the relay coil to ground.
Regards,
Jim Brown, K5JAZ
----- Original Message ----- From: "Eric Swartz - WA6HHQ, Elecraft"
<[EMAIL PROTECTED]>
To: "Todd Gahagan" <[EMAIL PROTECTED]>
Cc: <elecraft@mailman.qth.net>; "n2uz" <[EMAIL PROTECTED]>
Sent: Wednesday, January 05, 2005 4:43 PM
Subject: Re: [Elecraft] Is it possible to connect a amp to the K2
The K2/100 already includes a high voltage output keying line for
linear amplifiers on its KPA100 back panel. It can handle up to 200V
and 1A max. Most amps with -positive- keying voltages can be T/R keyed
from the K2/100.
I think the SB-220 uses a positive voltage so it should work.
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com