I am building the KPA 100. I have just tried the resistance measurements on page 41 of the Alignment and Installation. The resistance measurements for the Q1 and Q2 collectors will flash 11 or 12K ohms then jump down to -6.5K ohms and then count up to -3.5K and then stabilize. When I first checked the J3 red terminal it responded normally in about 20 seconds showing greater than 10 K ohms. Now even that is giving me inconsistent readings. The remainder of the readings in that table for the KPA 100 test points are okay. I saw a similar post in the archives from Dec 2004 but the thread ended without a response.
Comments Recommendations would be appreciated 73, KI4DGH Chuck Gehring _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com