Hi folks -
I have all options installed in K2 and all are working extremely well. I
am just finishing up with the K60XV. In doing the alignment I get a
slightly low voltage reading on 5300kHZ of .79 (where the manual says it
should no be less than 1.0 on page 11). All other voltages are within
range. Is this a significant issue or should I leave well enough
alone.....rather than do the VCO alignment again from the K2 manual
Alignment and Test Part II? Thanks for any advice in advance!
73/Tim NZ7C
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
