Hello Group,
I'm building my first K2, purchased about two months ago, and I've hit
a little bump during alignment and test (part 2).
During the PLL Reference Oscillator Range Test I came up with too
narrow a range (9.37 kHz somewhat below the 9.8 minimum)). My high
freq. ref. during the test was 12099.95, and the low was 12090.58). I
gather that my low point is not low enough. I did check the components
listed in the trouble-shooting section (D16, D17, C84, C85. L31) and
they are ok. I have also checked all soldering, and it looks fine.
I have looked over many of the messages on the list, but still wanted
to put out a request for help to those experienced with the K2. I have
seen some reference to a range as low as 9.1 kHz being ok (others say
it needs to be at least 9.8). I have also read that going to an L31
value of 12 uH is a solution.
Anyway, as always, helpful comments are welcome.
Mike/NR7F
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com