Jon:
If you are sure you intend to buy the audio filter, you can buy the kit
now and install the proper connectors right away. You can then use a
couple of scrap resistor leads as jumpers to make the required
connections - the same as if you had the audio filter installed and
wanted to remove it for some reason. The filter instructions tell you
how. Or perhaps you could buy and install just the headers now. You
can get the part number from the audio filter instructions on line.
That would allow you to choose between the filter and the DSP unit later
on and you'd only be out the cost of the header. BTW, I'm not a great
fan of desoldering, but I was able to remove the jumpers on my K2 with
no problem.
73's and good luck,
John AA0VE
jon howe wrote:
Any thoughts on a "solderless" solution to R18 and R19?
73,
ve8jj
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com