John, Are your filters installed in descending bandwidth with the widest towards FL1 and the narrowest toward FL5. The manual says this is a requirement.
73, Ted, W2ZK On 8/3/2010 8:28 AM, john wrote: > On 8/3/2010 5:51 AM, Bill W4ZV wrote: > >> john-61 wrote: >> >> >>> I have a k3 with the standard 2.7 filter and a 400hz cw filter >>> installed. The 2.7 is in slot FL3 and 400hz is in slot FL4. My >>> question is when you are adjusting the width of the filter should the >>> filter 3 number change when FL4 filter engages? When I adjust my width >>> down from 2.80 down to0.05 it always shows FL3 on the display. >>> >>> >>> >> Yes it sounds as you have not enabled the filter in FL4. The easiest way to >> check is to use the K3 Utility's Filter Configuration screen. >> >> 73, Bill >> >> > Thanks Bill but, but I have checked that already and even made sure in > the config menu that FL4 is ON. FL4 shows to be on in both locations. > Any other suggestions? > > thanks agian > John > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
