No Mike, the only problem I'm having is with the frequency and mode information into N1MM. It was working just fine right after I reset the RS242 to the correct (19200 b) baud rate; then I updated to the beta 4.03 firmware and now it does not talk to N1MM again.
Right after updating to the beta firmware, I tested the CW QRQ and found it to really be excellent. I went from 50 wpm up to 100 wpm in 10 wpm increments and the keying is just excellent. The characters are perfectly formed up to 100 wpm, but around 95 or so wpm, something like an AGC hang occurred. But they have done a really good job with this. Now if I can just solve the K3/N1MM communications problem I'll be all set..hihi. Tom - W4BQF -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Mike Sent: Tuesday, August 03, 2010 9:52 AM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] K3 and N1MM Logger Congrats, Tom. Do you have the K3 baud rate set to match? CONFIG:RS232? I have N/8/2 for the other parms. Can you connect to the K3 using the K3 utility? I'm a bit confused if you're having trouble with keying also, or just with the freq/mode stuff. 73, Mike On 8/3/2010 8:05 AM, Tommy Alderman wrote: > I just received a new factory wired K3 (s/n 4521) and I can not get the > K3/Logger to talk to each other. At this point I think the problem with the > K3 (and it's user!) but I am not sure. > Prior to setting up my K3, I had been using an IC-7700, keying with COM1 and > interfacing with COM3, so I know those ports were working. I have a home > brew keying circuit that works with various other programs, so I have no > need to key the K3 through its serial port. > What I have done is moved my keying circuit (it works fine with the K3) to > the K3 and moved my COM3 serial cable to the K3. In Logger Config, I changed > from the IC-7700 to K3, I used the recommended configuration for the K3, > i.e., 19600/N/8/1 and I have DTR and RTS set to 'Always OFF'. The CW/PTT > Port Adr is set for 3E8. > I have tried numerous other settings, N1MM recognizes it is connected to a > K3, but I get no frequency readout. > Sure would appreciate some constructive suggestions or some working > configuration settings! > Tom - W4BQF > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html