Brian, Your suggestion was right on the mark. I must have accidently tapped option 5 under CW Weight. I now remember briefly looking at that setting when it was mentioned by someone last week on the reflector. All I had to do was tap 5 to set it back to VFO NOR. Thanks to everyone for your great responses. I really appreciate it.
BTW, I received my P3 two days ago. All I can say is that it is one nice piece of engineering. Just another addition to the growing Elecraft legend! When can I order the KPA500? Dave, N4QS ----- Original Message ----- From: "Brian Alsop" <als...@nc.rr.com> Cc: "'Elecraft Reflector'" <elecraft@mailman.qth.net> Sent: Wednesday, September 01, 2010 6:15 PM Subject: Re: [Elecraft] New problem switching frequencies and modes with K3 FW 4.05 >I believe this problem is caused by setting the CW WGHT option 5 to VFO > OFS. Try setting it to VFO NOR and see if the problem goes away. > > I seem to recall having had problems like you are now experiencing when > this option was introduced many versions ago. > > 73 de Brian/K3KO > > > Dave Perry N4QS wrote: >> My K3 (SN 3132) has been working happily in sync with DX4WIN and N1MM for >> over a year now. Normally, when I double click on a spot within the DX >> spot window of DX4WIN, the K3 immediately changes to the correct spot >> frequency and mode. Same goes with N1MM. >> >> Just a few days ago I noticed that the K3 is not always changing to the >> correct frequency. The problem appears to occur when a spot causes a >> change in both frequency and mode. For example, if VFO A is set on >> 14.008.00 CW-R and I see a SSB spot for 14200.00, when I double click on >> the spot, the K3 changes to 14.199.42 instead of 14.200.00. Then if I >> click on a spot to go back to 14.008.00 the K3 changes to 14.008.58. In >> both instances I have to double click on the spot a second time to get it >> to change to the correct frequency. Note that the difference is +/- 0.58 >> kHz. The problem also occurs when switching from SSB to RTTY. It also >> seems to be occurring using both normal CW and CW-R. >> >> Last week I loaded the new 4.05 firmware. I am now wondering is this is >> a problem with the firmware. Or have I somehow changed a setting? The >> K3 worked perfectly for over a year. Something has changed. Any help >> would be appreciated. >> >> Dave, N4QS > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html