I have noticed the cyan cursor has gotten out of sync on rare occasions, a mode change always corrected it. I cant replicate your sequence of band change, mode change, etc. It works fine here every time..
Jim k4JAF ----- Original Message ----- From: "Phil Hystad" <phys...@mac.com> To: "Elecraft Reflector" <Elecraft@mailman.qth.net> Sent: Thursday, September 02, 2010 5:48 PM Subject: [Elecraft] P3 Cursor Position Incorrect After Band change... > On my P3, I notice that the little cyan cursor location does not align > itself properly during a band change that also involves a mode change. > For example, switching from 17 Meter band with USB to 20 Meter band with > CW leaves the cursor aligned to the right of the center position as it > would be for USB but not as it should be for the CW signal. All IF shift > controls are in their normal position. Indeed, a power off and power on > cycle of the P3 resets the cursor location to be correct. > > I figure if a power-off/power-on fixes a problem then there probably is a > problem. > > Anyone else seen this same thing? If it is unique to my P3 maybe I have a > very special P3 that might be worth a lot of money (sort of like an old > stamp with a flaw in it). > > 73, phil, K7PEH > K3 #3799, P3 #0030 > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html