Geert Jan, I tried your suggestion. No luck. After setting up trn3 for 432
MHz, IF=28, Offset = 0 trnaddr 3, ., I depressed Band +-, inband appears,
then ----4. I enter 32100. The display then reads 4321000. I do it for
both VFOs. A / B them they are both at 4321000. As soon as the VFO knob is
moved BOTH vfos become corrupted on the display. A=405900.0 ; B= 405810.0.
Input from VFO knob locked out, display frozen. Display never goes blank to
indicate an unlock condition. Can switch to other bands... Firmwares are
latest, latest, latest... BAD MCU?? Ser # 25xx with all updates.
Ben
----- Original Message -----
From: "Geert Jan de Groot" <[EMAIL PROTECTED]>
To: <elecraft@mailman.qth.net>
Sent: Monday, May 09, 2005 5:08 AM
Subject: [Elecraft] Re: Transverter TRN3 and TRN6 setup problems
On Mon, 9 May 2005 04:01:50 -0400 (EDT) [EMAIL PROTECTED]
wrote:
After setting up the TRN3 and/or TRN6 parameters in the K2 and returning
to
normal operation, as soon as VFO knob turned the frequency on the display
go to
what seems to a randome one, AND VFO input is ignored (?) as dispaly is
"locked". Other TRN bands (TRN1, 2, 4, 5) work OK.
I have not seen this problem quite as described, and am running the
latest
firmware in the QRP configuration with internal tuner. One thing that
might be happening is the initial displayed frequency might be
uninitialized
so is randomly set out of band. Try to use the direct frequency input
method to set the expected frequency. (Band- and + together, enter
digits).
Having done some experiments over the weekend myself, I definitely
found that the K2 gets confused if you change the RF frequency,
or the IF frequency.
Repeat-by: set TRN1 for 144 MHz, IF 28 MHz. Manual-enter 144.000 MHz,
Change the IF to 14 MHz. Note that the display is now off, and
the PLL is out of band (and probably out of lock, alas).
Workaround: Manual-enter the start frequency after setting up
a transverter band. Do this on both VFO's!
I don't know what code space we have in the main MCU these days
(this has been a stumbling block from 1.x to 2.x firmware, and AFAIK
code size issues are preventing some other things from being implemented),
but IMHO it would be good if the K2 would auto-reset both VFO's
if either the RF frequency, or the IF settings change.
Geert Jan
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
