Please add my name to this request. I have the same setup as Phil and Roger. It would sure be handy if the amp enable line setting could be custom configured to adapt to this specific environment.
Lu - W4LT K3 # 3192 ---------------- Subject: Re: [Elecraft] K3 Amp Key configuration request To: Phil & Debbie Salas <dpsa...@tx.rr.com> Cc: elecraft@mailman.qth.net Message-ID: <4d2ba00d.2090...@roadrunner.com> Content-Type: text/plain; charset=ISO-8859-1; format=flowed Phil & Debbie Salas wrote: > I use my K3 with an Ameritron ALS-600 amplifier and MFJ-998 autotuner (hey, > the KPA-500 and KAT-500 aren't available yet). Anyway, I tune the MFJ-998 > by leaving it in the full auto position and then just press TUNE on the K3. > I set my K3 TUNE power for 15 watts which is a perfect level for the > MFJ-998. However, the amp enable line on the K3 goes low even when using > TUNE, and so I must remember to place the amp in standby before checking and > tuning SWR. Otherwise the amp will put out power momentarily (60-100 watts) > until the MFJ-998 interrupts the amp-key line if it needs to tune. It would > be nice if the amp-enable output of the K3 would not go low when using TUNE > on the K3. Maybe a menu set-up option? > > Phil - AD5X > > ______________________________________________________________ > > Same situation here. I'd like to see this too. 73, Roger No virus found in this outgoing message Checked by PC Tools AntiVirus (6.1.0.25 - 6.14880). http://www.pctools.com/free-antivirus/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html