Coming late to this thread - Phil, don't use the preamp. You do not need it. Open up the mic base and wire around it. It can be a source of RFI. My MIC level is 29, the impedance switch on the mic is at 500 ohms, and I get good audio reports on my MC-60A. The up/down buttons are useful on occasion.
Monty K2DLJ On Mar 6, 2011, at 12:02 PM, Phil Hystad wrote: > Yes, I may plan to do that if I decide to keep this mic. The price is OK and > I am leaning towards buying it because if I did not want to keep the mic I > could probably recover my cost by selling it. > > phil > > > On Mar 6, 2011, at 8:51 AM, Joe Subich, W4TV wrote: > >> >> Phil, >> >> The K3 provides voltage on pin 6 but the MC-60 expects >>> voltage on pin 5. What I don't understand is IF I were to rewire >>> this so that the voltage was placed on pin 5 (I assume I would do >>> this within the base itself and not rewire the actual connector) then >>> do I create a problem for the K3?? I am assuming that I would have >>> to make sure that pin 5 was NOT connected to anything but that I took >>> the pin 6 voltage offered by the K3 and route it to whatever pin 5 >>> was hooked up to. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html