It's audible here only if I put my fingers on the P3 screen and find the most sensitive spot, but it's never strong. It's completely inaudible without touching the P3's screen.
Disconnected the 2-meter antenna and touched a short wire to the ANT3 connector and it got very loud, suggesting that it's noise being picked up by the antenna, at least for me. My 2-meter antenna is on the roof about 15 feet above the rig. If it's not being picked up by the antenna there must be some other path into the K144XV perhaps through an open ground between units, etc. Ron AC7AC -----Original Message----- David Yes, I do. Try placing your hand immediately in front of the P3 screen and it will act as an aerial, making the situation quite a bit worse. John G4ZTR -----Original Message----- While operating on SSB on 144.225 MHz using the internal K144VX transverter I am getting broadband noise around that frequency when I switch on my P3. The noise is quite strong, about S7, and shows clearly on the P3 screen. If I move the P3 about six inches away from the K3 the noise disappears. Removing the 2 metre antenna also removes the noise. I would be grateful if anyone else with a K144XV and a P3 would check to see if they get the same problem? Many thanks 73 de David G4DMP -- + - - - - - - - - - - - - - - - - + | David M Pratt, Kippax, Leeds. | | Website: http://www.g4dmp.co.uk | + - - - - - - - - - - - - - - - - + ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
