Tom, You made some cuts and added some wire to the Control Board when adding the KIO2 if your K2 SN was less than 3000 (the new boards already have this change installed.
No need to reverse that wiring, just unplug the KIO2 cable and all will be well. 73, Don W3FPR On 3/28/2011 11:17 PM, Tom McCulloch wrote: > I have an early serial numbered K2 (#1103) which I am running barefoot. > Among other options, I have installed the KI02 and ATU. Those who have > built the earlier models will recall the need to cut some of the the > traces on one of the front panel boards (there are two boards up there - > I forget which one was cut). > > I now find it necessary to remove my KI02 and I will probably have to > replace it (don't ask!). My question to the group is -- in light of my > having cut those traces, will the ATU still tune if I remove the KI02? > (I forget if we cut the traces when installing the KI02 or the ATU). > > I hope at least some of this makes sense. > > Thanks in advance for your usual help. > > 73 > Tom WB2QDG > K2 1103 > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
