"RC" KC5WA wrote on 06/01/05 09:50 ET: > On page 26 right coluum last instruction reads > "Place two 3/4" (19mm) spacers over the leads > of each back light LED as shown in Figure 5-9" > ------------------------------------------------- > Now to the best of my knowledge NO SPACERS > such as those described fig 5-9 were in the parts list. > Unless it is the two 8mm x 8mm square black pads. > and these need two be split in half and stacked to get > the required 1/8 spacing on the diffuser. Thanks for > any help...
RC, The spacers are the little pieces you previously will have snapped off of the switch spacing tool. 73, Mike AB3AP _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com