Mike;
That is way out of spec. Make sure you all of the components installed in
the correct location. Double check that you go the varactor diodes in the
right location; this circuit uses two different types. Also check the DC
voltage on the varactor diodes to make sure it varies from 0 to 8 volts. If
everything checks out okay, ask Gary to send you a new crystal and check
that one out.
-John
KI6WX
----- Original Message -----
From: "Mike KL7R" <[EMAIL PROTECTED]>
I have completed Allignment and Test, Part II
I need help with the PLL Reference Oscillator
Range Test:
Ref High Freq 12098.1
Ref Low Freq 12092.56
Range (kHz) 6.35
Which is out of spec.
The Rev E and Rev F books say minimum of 9.8 khz
I am using a single XTAL at X1/X2
(ECS V 12.09-S KOREA G0)
I am using a shielded 10mh at L31)
Rev B boards. Rev E manual
The rig works on receive on 40 meters FB
I dont have the K2 Temperature-Compensated PLL Reference Upgrade.
How much does that Upgrade cost?
Mike
KL7R
Was Ser #1938 (unbuilt - then upgraded to rev b boards)
Now Ser #3373
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
