while doing the zero beat led I went ahead and put in the rant led too since I didn’t wanna reopen the front panel again. I don’t have the k160 board yet. I soldered from the 2.7/4v to the led thru the resistor 180ohms to pin 7. I also put in one 4700 cap to a ground on the control board plug and pin 7 of the rf board. That was all. My kaf2 stopped being recognized after, sort of. It would still work you hold it and the leds for it came on and you could hear the difference in audio but the screen display would say not installed. The clock would also say not installed but in the menu it would recognize and show on or off. So after disconnecting the rant led from pin 7 on the front panel the kaf2 works normal now.
Wow that was a lot, my question is do I need to isolate pin 7 from the auxbus by cutting the trace like Im supposed to do on the 160 board when I get it? Theirs 2 red arrows with a space on your schematic I assumed that was a plug. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
