Hi all,
I know I am always missing stuff in the manuals, but I have looked and
not found the answer to this question.
I am installing the KIO2 in my K2 #402 and the two threaded studs that
connect the female DB9 connector to the chassis at the rear have a
threaded shaft portion which is 3/16 inch long. This will clearly
thread past the top of the hex nuts and run into the side of the circuit
board. I am _sure_ (;o)???? yeah!) I installed the board to the db9
correctly. I am ready to take a dremel cut off disc to the threaded
shafts to shorten them.
But this can't be the first time this has happened, so I am thinking I
goofed somewhere.
How about it?
Thanks,
Steve, W2MY
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
