It's not a bug, it's a documented limitation. Actually, it can be a feature: if it's set to 10 Hz and you tap one of the knobs, it displays the shift or the width without changing the control's function!
On 6/7/2011 6:51 PM, Rich - K1HTV wrote: > Joe, > I'm aware of the SHIFT granularity being settable from 50 Hz to 10 Hz. > What I > was questioning is why, when this change is made, that the K3's HI CUT and > LOW > CUT controls are disabled. After you set CONFIG:PB CTL to 10 Hz, when you > press > either HI-CUT or LOW-CUT. nothing happens and you can no longer roll off > either > side of the passband as you could when PB CTL is configured to 50 Hz. Is this > an undocumented feature? If so, I think it is a bad one. > > 73, > Rich - K1HTV > > = = = > > -----Original Message----- > From: Joe Subich, W4TV [mailto:li...@subich.com] > Sent: Tuesday, June 07, 2011 19:42 PM > To: elecraft@mailman.qth.net > Subject: Re: [Elecraft] K3 Hi Cut& Low Cut granularity bug? > > >> Also, when the SHIFT granularity (CONFIG:PB CTL) is changed from 50Hz >> to 10Hz,> the Hi Cut and Low Cut controls do not work at all! Is this >> a BUG ora FEATURE? I'm presently using K3 firmware update MCU >> 4.36 . > > Feature ... as documented every since the 10 Hz steps for shift/width was > first > provided in beta testing. > > 73, > > ... Joe, W4TV -- Vic, K2VCO Fresno CA http://www.qsl.net/k2vco/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
