Thanks, I spent almost 2 hours looking for the missing pieces, without success. There are several alternatives I can think of to use as temporary spacers. Fortunately this has been the only mishap during assembly, and hopefully the last.
Ron VE8RT On Fri, 2011-06-17 at 15:26 -0700, Mike K8CN wrote: > Hi Ron, > > Check Figure 5-9 on page 27 of the rev. H manual - the spacers are used only > temporarily to set the height of the backlight assembly prior to soldering > its pins in place. I suppose any other means you might devise to keep the > backlight 1/8 inch off the front panel board and parallel to it would be > acceptable (presuming you can extract the spacer after the backlight pins > are soldered :) ). Don, W3FPR may have a better suggestion. > > 73, > Mike, K8CN > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/K2-Front-Panel-assembly-question-tp6485680p6489056.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html