I meant to say change the fuses and reconfigure the fuse block... I was actually reading the manual when I asked that question. On other amplifiers I was required to change internal transformer wiring to setup for 220v. That's what I meant to ask.
So switching the fuses and changing the fuse block is all I need to do. No other internal wiring required. Doug -- K0DXV On 7/9/2011 9:43 AM, Ron D'Eau Claire wrote: > When you change the fuses, you insert the fuse holder so 220 is visible in a > little window instead of 115. That changes the wiring to the power > transformer input for 220 volt mains operation. It's described at the > beginning of the Owner's manual. > > Ron AC7AC > > -----Original Message----- > Am I correct in assuming that in order to run the KPA-500 on 220 volts > all that is needed is to change the fuses to the provided 6 amps, wire > the correct plug on the power cord and the power supply will adjust > accordingly? > > Thanks, > > Doug K0DXV > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html