Tom, The instructions are correct.
73, Tom Amateur Radio Operator N5GE ARRL Lifetime Member QCWA Lifetime Member On Wed, 17 Aug 2011 17:30:10 -0400, "Tommy Alderman" <alderm...@windstream.net> wrote: >I'm sure this has been discussed before but if so, I have missed it. > >On page 24 of the P3 Owner's Manual, Rev. B, March 29, 2011, under the >heading of Amplitude Calibration the forth button down, it states to set the >signal generator for 7040 kHz and the following button below says to set >the transceiver to approximately 7015 kHz so the signal is centered on the >right half of the display. Is this a typo? If not, can someone please >explain the purpose of doing this? > >Thanks and 73 > >Tom - W4BQF > [snip] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html