Hi Don Once again thank you for your very quick and concise reply.
I've just returned from work so later this evening I will go over the board with my loupe and check all the solder joints. As you say the next most likely suspect will be a poor inductor connection so I'll be paying very close attention to the solder and tinning of the leads. I will update once the investigation is complete. Regards Nidge (G0NIG) IO93dv -----Original Message----- From: Don Wilhelm Sent: Sunday, August 21, 2011 7:38 PM To: Nigel (Nidge) Smith Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] K2 KNB2 Issue Nidge, The only components the KNB2 adds to the receive path are in the bandpass filter. If you have checked capacitors C3 through C7 for correct values (and are all in the right places) and well soldered, the next on the suspect list is L1 and L2. You say you have checked the number of turns, so look carefully at the connections on the solder side. If you see a ring in the solder around any lead, that indicates the lead was not well stripped and tinned. Remove the inductor and re-tin the lead. Check to be certain R8 is 120 ohms and R9 is 300 ohms - swapping them will significantly reduce the signal. If all seems well with the bandpass filter proper, do a test after removing capacitors C16 and C8. With these capacitors removed, the NB will not function, but it assures that the only components in the signal path are the bandpass filter components. If you have come this far and it still reduces the signal, I would conclude you have a bad capacitor in the bandpass filter - obtain replacements for capacitors C3 through C7 on the premise that one is bad. It is difficult to tell which one unless you remove them and measure with a capacitance meter. 73, Don W3FPR On 8/21/2011 2:14 PM, Nigel (Nidge) Smith wrote: > Hi All > > I have an elderly K2 which had the original KNB2 installed, the one with > the two trimming capacitors in the > bandpass filter circuit. I ordered the revised board and this was built > yesterday. The issue is that with > the new board installed the sensitivity is very much reduced which is > confirmed using the XG3 at 50uV > output, with the original board the S-meter indicates S9 where as with the > revised board the S-meter > indicates S3. I have checked that all the components are in all the right > places paying particular > attention to the capacitor values, that all the inductors have the correct > number of windings and that > there is continuity between each end of the inductionr (0.04Ohm). > > Is there anything I can further check? > > Test equipment available: > > XG3 > 50MHz Oscilloscope > MFJ Antenna Analyser > Fluke 77 multimeter with RF probe. > > As an added bonus today I was using the K2 at a special event where we had > multiple > stations running. One of the other stations came on my frequency and > transmitted. > The result (with the KPA100) installed is that I get a constant high > current reading > on the display and SWR of 9.9, I’m presuming that the diodes D16 and D17 > in the > KPA100 will have been fried (?) > > All recommendations greatly received. > > Regards > > Nidge (G0NIG) > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
