Quote "Finally getting started on Serial 366. Got to page 22 - attaching the Z-bracket to the heat sink. Using the 5/16" flat head screws all of the screws bottom out before the bracket is tight against the heat sink. Has anyone else seen this? I did double check the screw length. I don't think the bracket should be loose. "
Hmmm! Unusual. Earlier this week I finished assembling #402. I used hardware exactly as called for in the instructions. No problem with assembling the Z-bracket onto the heat sink, nor with fastening the bottom cover. I was one screw short at one point during the assembly, but simply used one from the "extras" package to complete the work. I have been successfully integrating the KPA500 into my station, and giving it a good workout during the past couple of days. 73, Doug, VE3VS -- View this message in context: http://elecraft.365791.n2.nabble.com/KPA500-Z-Bracket-Assembly-Question-tp6821078p6824033.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html