Hi Don and Alan, On my K3 and P3 to solve an initial comms problem with my software and the P3 I set the computer to P3 speed to half that of the fixed P3 to K3 speed. Helped get rid of some glitches that actually went away later when flrig 1.2 came out.
Elecraft also was helping debug the problem. As Don says it is computer to P3 with one serial cable and P3 to K3 with a second serial cable. Works fine now. 73, tom n4zpt On 10/3/2011 8:50 PM, Don Wilhelm wrote: > Alan, > > I don't understand why you have to disconnect the P3. The P3 has a > "pass-thru" RS-232 connector. Have you tried connecting the PC to the > RS-232 connector marked PC on the P3? > > If DX Lab interferes with the P3 to K3 communication, that may cause > problems, but for most applications, that connection works just fine. > > 73, > Don W3FPR > > On 10/3/2011 8:40 PM, Alan Grant wrote: >> I have been trying to run DX Lab on my K3, but have to disconnect the P3 >> Pan adaptor, do Elecraft make a double adaptor for the RS232 line, or if >> I buy some RS232 -USB adaptor and plug it into a USB multi adaptor, can I >> run these other applications at the same time as the Pan adaptor? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html