Dick, When the KPA500 is hooked up and in operate mode you can set each bands output. When the amp is in standby mode then you can set the output to a different level. This can be done per band if you set the PWR Set to per band instead of normal.
The K3 should tell you that it sees the KPA500. Mike W0MU J6M CQ WW DX CW Contest 2011 J6/W0MU November 21 - December 1 2011 W0MU-1 CC Cluster w0mu.net On 11/12/2011 9:27 PM, Dick Frey wrote: > How do I teach my K3 to go back to 100W when the KPA500 is off? > Yes, the control cable is connected. > 73, Dick > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
