That did it! I had the TECH MD menu turned off and wasn't finding AUTOINF.
Thanks for the help to everyone who responded! Jack - WE5ST ________________________________ From: mike_k2mk <k...@comcast.net> To: jlberry <jlbe...@yahoo.com> Sent: Fri, November 25, 2011 3:38:03 PM Subject: Re: SDA-100 setup with Elecraft K3 Hi Jack, I have the older controller and the mode used is Kenwood. But be sure to also observe the following note on page 44 of the K3 manual under Automatic Antenna Control. You will have to make the following configuration change. CONFIG:AUTOINF should be AUTO 1 73, Mike K2MK --- In step...@yahoogroups.com, "jlberry" <jlberry@...> wrote: > > Should the Orion or Kenwood mode be selected when using the K3 with SteppIR's >SDA-100 controller? Can't get it to work with either mode, just thought I >would >check with the list. > > Thanks! > Jack - WE5ST > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html