>>> Suggested behavior: Since the P3 has no idea in which direction >>> tuning will subsequently occur, the cursor/frequency should be >>> placed in the exact middle of the P3 display. In that manner the >>> P3 is useful to both sides of the memory-recalled frequency.
I'm not so sure that placing the signal in the exact center of the display is correct either. Rather, the signal should be placed in the "central half" of the display consistent with maintaining even 5/10/25 KHz upper/lower frequency boundaries. 73, ... Joe, W4TV On 2/15/2012 8:19 PM, Gary Ferdinand wrote: > Hi Mike, > > Toggling between fixed tune and tracking mode is certainly faster and more > predictable than anything I've found as a work around. Thanks for the > suggestion. I'll give it a try. > > Since I'm not always contesting, I'd like to find a way to make the P3 > cursor be well behaved without using a macro from a connected computer. If > I could assign a macro to a P3 FN key, that would be a great general > solution. > > Thanks for the toggle suggestion, Mike; it's a good one. > > 73/Gary W2CS > > >> >> I can't say that I have experienced your spotting situation but I would >> like to describe a different way of getting a signal into the center of >> the P3 screen in Fixed-Tune mode. I have P3 function key FN4 set to >> toggle between Fixed-Tune mode and Tracking mode. By pressing it I get >> the signal of interest to the center of the screen in Tracking mode and >> pressing it again returns me to Fixed-Tune mode except the signal stays >> in the center. The double press can be done instantly. >> >> Then I took that one step further. I'm generally on CW using WriteLog >> for contests and as a general logging program. I'm always using the K3 >> Auto Spot to zero in on a CW station of interest. I created a macro in >> WriteLog to activate the K3 Auto Spot and to twice activate P3 function >> key FN4. It's really cool. >> >> 73, >> Mike K2MK >> >> >> >> >> Gary Ferdinand wrote >>> >>> I should like to suggest that a boundary-condition change be made to >>> the >>> P3 >>> display behavior. The current behavior I view to be a firmware >> defect. >>> >>> P3 mode settings are: Fixed Tune mode. Half Span. >>> >>> Current behavior: When recalling a frequency from a K3 memory and >>> that frequency is off the current display of the P3, the P3 sets the >>> cursor (and therefore frequency) at the left edge of the screen. This >>> obscures everything below the memory-recalled frequency. >>> >>> Suggested behavior: Since the P3 has no idea in which direction >>> tuning will subsequently occur, the cursor/frequency should be placed >>> in the exact middle of the P3 display. In that manner the P3 is >>> useful to both sides of the memory-recalled frequency. >>> > <SNIP> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html