I wanted to install the latest firmware beta release (4.47).
The process started, on the K3 display MCU LD appeared, but after a while the 
message appeared, that the update failed.
The K3 stayed in the MCU LD mode and the K3 utility showed that there is a 
communication problem with the COM port.
Trying to reactivate the COM communication failed with all possible COM ports 
my ELTIMA virtual port cable creates.
Turning the K3 on and off didn't change anything, the MCU LD mode stays on. 
Also reinitializing the ports by turning the computer off and on again didn't 
change a thing, I could not get the COM port communication started again.

Does anybody have an idea how to get back to normal without  starting the EE 
INIT procedure (loosing all parameters)?

Thanks in advance for your help!!

Axel, DL3ZH
                                          
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to