That's one for the Elecraft developers to answer here on the reflector…! On Thursday, Mar 1, 2012, at Thursday, 9:36 AM, K4GM-George wrote:
> But must the K3 be used with a KPA500 for this to occur or is there a command > in the config somewhere to tell the K3 to recall a power level for each band > so that any amp can be used??? > > George K4GM > > On 3/1/2012 11:58 AM, Jim Bennett wrote: >> Each band. And it recalls the proper level depending of if the KPA500 is in >> standby or operate mode! >> >> On Thursday, Mar 1, 2012, at Thursday, 8:43 AM, K4GM-George wrote: >> >>> Does the K3 recall output levels ONLY when used with the KPA-500 or will >>> it recall the levels for each band irrespective of the amp used ? >>> >>> George K4GM >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:Elecraft@mailman.qth.net >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >> >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html