See Figure 4 on page 3 of the instructions showing how to remove the fan panel, "If Equipped with the K144XV, Unplug the ANT3 Cable Here" and an arrow pointing to the connector on the K144XV module.
73, Ron AC7AC -----Original Message----- One issue with the instructions is that they have you remove the fan panel, or the blank panel if you don't have the KPA3. What is not taken into consideration is if you also have the K144XV installed, with it's ANT3 connection on the fan panel. The instructions do not tell you to remove the ANT3 cable/connector. I was able to do the mod (carefully) without completely removing the fan panel, just loosening the screws. The instructions also never tell you to re-install the bottom rear panel, but I imagine most ops will remember to do that... 73, Bruce, N1RX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html