That Smartcharger article is on my website www.w3fpr.com. Steve, Looking at the end of your post, I see that you currently have a 1 amp fuse which is too small. Your 2.4 amp power supply is OK if you are limiting power to 5 watts, but if you want to run 10 to 12 watts (how about SSB on peaks) the power supply should be increased to at least 3 amps. I usually recommend a 6 amp supply at 13.8 volts.
73, Don W3FPR On 4/26/2012 2:21 PM, Tom McCulloch wrote: > Hi Steve, > If you have the battery installed in you K2 I'd recommend the A&A > Engineering (?) PS. It keeps the battery charged as well as powering > the K2. I don't think it'll be big enough if you go to 100 watt amp, > though. Don , W3FPR has a write up on on his site (or he used to anyway). > > Good luck with the K2 > > Tom > WB2QDG > K2 #1103 > > On 4/26/2012 11:35 AM, Stephen Roberts wrote: >> Well, just got my pre built K2 and I'm looking for recommendations for >> external in line fuse as well as power supply. I recently fried my OHR rig >> and will not power up any of my rigs without the proper fuse again. >> >> I currently have an inline 1A fuse with PP connectors and a 2.4A power >> supply. Will that do it? >> >> Steve >> W1SFR >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html