Mike, Your battery is not fully charged 13.3 volts is just not enough to fully charge the battery.. If you are going to use your power supply to charge the battery, you will have to increase your power supply voltage to 14.1 to 14.3 volts - there is a pot inside the Astron. The battery does not see the full power supply voltage because there is a drop across diode D10 in the K2.
The alternative to increasing the power supply voltage is to add a Smartcharger. Take a look at my website article www.w3fpr.com for how to do it. That type charger needs a direct connection to the battery (but fused for safety). If you want to see the specification for that battery, it is at http://www.power-sonic.com/images/powersonic/sla_batteries/ps_psg_series/12volt/PS-1229_11_Feb_21.pdf 73, Don W3FPR On 4/28/2012 3:31 PM, Mike Weir wrote: > Good afternoon all, I have the battery from Elecraft for my K2 and I charged > it for 16 hours using my Aston RS20M. The voltage reading from the Astron > supply using my Fluke 179 was 13.78 volts and the K2 was reading 13.3 volts. > My question is after the 16 hours of charging with the Astron power supply > removed from the K2 my voltage reading on the K2 is 12.1 volts and .042ma's. > Is this voltage within spec's for the K2's battery after a 16 hour charge? > Mike > VE3WDM > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
