I use my K3 on 6 meters with a concerted SB-220. When using the PR6 connected to the KXV3 as intended and using the amp, the GaAs FET is destroyed immediately. My work around was to employ an external TR relay on the K3 to switch TX RX, connecting the PR6 to the RX side of the relay and to the RX input of the KXV3.Using this arrangement has worked fine for the past few years.
With E skip season approaching I thought that I would try to resolve this problem and get rid of the extra RF plumbing. My initial thought was the TR relay in the amp might be too slow and RF was being reflected back into the K3 during the transition from TX to RX. After looking at the K3 block diagram I doubt that this is the case as the PR-6 should be switched out of the circuit well before any RF is present at the output. For reference the TR relays in the amp are spec'ed at 8 msec to switch and the K3 is set at 8 msec TX delay, which I believe is the default. Any ideas? 73 Gregg W6IZT ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html