Did the +12V mod to my K3 with Sub RX yesterday. As you say the instructions did not mention the Aux cable, however I found that moving the cable to the rear of the K3 and then extracting the PA towards the front was no problem. Just needed to take care.
73 Stewart G3RXQ On Fri, 18 May 2012 19:28:51 +0000, Brian Alsop wrote: > Did two of these today. One had a subrx. One did not. > > Instructions didn't mention that the subrx aux cable interferes with > pulling the K3's amp module. At least I was concerned about bending amp > connector pins if it were tried. > > Ended up also removing the I/O board and pulling out the cable from the > subrx. There is perhaps a better way. > > Not a big deal but extra work. > > 73 de Brian/K3KO > > > ----- > No virus found in this message. > Checked by AVG - www.avg.com > Version: 2012.0.2176 / Virus Database: 2425/5007 - Release Date: 05/18/12 > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
