Re-check the displayed power please - if it says 0.2 watts instead of 2 watts, there is actually no power at all - the 0.2 watt indication is residual in the power measuring circuits (a.k.a. noise) and at a glance it is easy to interpret as 2 watts.
As Gregg stated, the most likely first 'attack' is D9 and the T/R switch components - arbitrarily replacing the diodes would be a sensible action because some may work now only to fail later, so it is inexpensive insurance (1N5711 and 1N4007 diodes are not costly). 73, Don W3FPR > -----Original Message----- > > I've been thru this and found that most of the damage was to the > reflected/forward power measuring circuit and the antenna > switching diodes. > I would start there. > > Gregg R. Lengling, W9DHI, Un-Retired > K2/100 SN 3075 > http://www.milwaukeehdtv.org > > ----- Original Message ----- > From: "Vic Rosenthal" <[EMAIL PROTECTED]> > To: "David" <[EMAIL PROTECTED]>; "Elecraft Reflector" > <elecraft@mailman.qth.net> > Sent: Friday, August 12, 2005 10:54 AM > Subject: Re: [Elecraft] LIGHTNING Question > > > > David wrote: > >> Well the astron rs 35 was also toasted by the lightning so I have been > >> using a deep cycle battery and a battery charger to keep the battery > >> charged but the voltage is rock solid on the meter on the power stripe > > > > See what the K2's DISPLAY command says. > > > > When you say that you can't get over 2 watts do you mean that > > > > a) when you turn the power control all the way up it says 2 > watts on the > > display, or > > > > b) when you turn the power all the way up it says 15 watts, but your > > wattmeter shows only 2 watts? > > > > Are you testing it by holding the key down, or are you pressing > TUNE? Tune > > limits the power to 2 watts with current ffirmware. > > > > -- > > 73, > > Vic, K2VCO > > Fresno CA > > http://www.qsl.net/k2vco > > _______________________________________________ > > Elecraft mailing list > > Post to: Elecraft@mailman.qth.net > > You must be a subscriber to post to the list. > > Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > > Elecraft web page: http://www.elecraft.com > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > -- > No virus found in this incoming message. > Checked by AVG Anti-Virus. > Version: 7.0.338 / Virus Database: 267.10.8/71 - Release Date: 8/12/2005 > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.338 / Virus Database: 267.10.8/71 - Release Date: 8/12/2005 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com