Please share your solution as I plan on powering the KPA500 with a KX3 too Thanks, KD3TB
On Sunday, June 10, 2012, Adrian wrote: > ACC2 IO setting > LO=PTT (input; apply 0 V or ground to > > activate PTT) > > > > > I can't figure out how to set the ACC2IO on the KX3 so that it will key > the KPA500 properly. I currently have the >ACC2IO in the off position. When > I connect the cable between the ACC2IO and the PA Key on the back of the > KPA500 it puts >the KPA500 in a transmit mode. I have to manually put the > KPA500 in standby to receive and then Operate to transmit. I >have tried a > number of different settings on the KX3 and KPA500 with no success. What > am > I doing wrong? (incidentally >the KX3 will drive the KPA500 to almost 200 > watts output). > > > > >Dave WA6DKN > > > > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net <javascript:;> > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- Irwin KD3TB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html